Bosch's
newest generation injectors are now available in a 2200cc high impedance
injector. |
|
|
|
|
|
|
Features
Fits
all Honda H Series engines.
- ALL ACCESSORIES ARE INCLUDED WITH EACH SET
OF INJECTORS, INCLUDING THE INJECTOR CLIPS.
If
you're unsure if these will work in your application, give us a call
and we'll help you figure out what it will take. - Finally, a great solution for people that need more than
1500cc/min!!
- The new Injector Dynamics ID2000 flows 2200cc/min at 3 bar
(43.5psi) and is high impedance. That means no injector resistor or
injector driver is needed. With the capability of running up to 130psi
and flowing 3700cc/min, the needs for running multiple injectors per
cylinder are gone on all but the most demanding methanol applications.
- With
the most linear flow in it’s class, great atomization and full
injector dead time information provided, there really is no competition
for the ID2000. Check out this video to see how
well they run in a
worst case scenario, a bone stock 120hp car!
- Each injector
includes the necessary adapter top and electrical
connector. The adapter tops mechanically lock to the injector and also
incorporate a 7 micron replaceable filter.
Price is per set of vehicle
specific injectors and includes
the adapters for the top and an injector clip with pins. Also available
are vehicle specific Plug N Play harnesses, so no rewiring needed.
- High
Impedance, no need for injector drivers or injector resistors.
- All of our
injectors are sold in matched sets. The sets are
matched not only by flow, but by injector dead time. Very very few
people are offering this kind of matching consistency. By matching the
injectors based on both dead time and flow, you end up with a set of
injectors that are matched to 1% from minimum to maximum pulsewidth.
If you don't match the injectors based on dead time, you can easily end
up with a 4-10% flow variance from injector to injector in the 2-3 ms
range, where most of the life of the injector is spent. This can have
a huge affect on idle quality and how smooth the engine runs.
- Running
peak
and hold injectors with an injector resistor makes matters even
worse. By lowering the voltage to the injectors, the dead time
deviation increases considerably, which increases the fuel flow
deviation considerably as well
Priced per vehicle specific
set. Available individually as well .
| |
Visit
www.InjectorDynamics.com for more information
Not recommended for use with oxygenated fuels such as VP Q16 or VP Import. These are totally compatible with VP C16, VP C23, Methanol, or any Ethanol blend (E85, E98, etc).
This product was added to our catalog on Wednesday 30 June, 2010.