Simple, do-it-yourself, designed to replace your existing belt-driven mechanical water pump. The Controller will vary the speed of the EWP in response to the engine temperature. If the engine temp goes 3 degrees C over the target, the Controller will run your radiator fan until the target temp is restored. Five temperature settings on the Controller for either maximum power or fuel efficiency! The Controller is designed to allow the EWP to run on for 2 mins (or set - 5°C) after hot engine shut down thus eliminating heat soak.
Specifications:
| Ewp Operating Voltage | 3v Dc To 15v Dc
|
| Ewp Maximum Flow | 115 L/Min, (1822 Gal / Hr) At 13v Dc
|
| Ewp Operating Temp | -40°c To 130°c (-4°f To 284°f)
|
| Ewp Weight | 980 Grams (2.16lb)
|
| Ewp Burst Pressure | 500 Kpa (70 Psi)
|
| Ewp Fits Hose Sizes | 32mm To 51mm (1 ¼" To 2")
|
| Dig Cont Input Voltage | 12v Dc To 13.5v Dc
|
| Dig Cont Operating Voltage | 5v To 13.5v
|
| Dig Cont Max Current | 12a
|
| Dig Cont Operating Temp | -20°c To 60°c (5°f To 140°f)
|
| Dig Cont Setting Temp | 75°, 80°, 85°, 90°, 95°
|
| Dig Cont Weight | 90 Grams (3.2oz)
|
Kit contents:
- EWP 115 Pump 1
- Wirning harness 1
- Sleeve 3mm rubber adaptors 2
- Hose clamps 2
- Assorted hardware bag - includes relay # 0533 1
This product was added to our catalog on Friday 27 January, 2012.